Shall we start again?

It's been 6 years since I last posted on this blog.

6 years....

That's a long time.

Some life and career changes made me move away from some of these hobbies I had.

But now I'm thinking back. I want to start again.

DJI Phantom - By Vicki Burton from United Kingdom (DJI Quadcoptor Phantom Vision Plus) [CC BY-SA 2.0 (http://creativecommons.org/licenses/by-sa/2.0)], via Wikimedia Commons

Shall we start again?
I know it wont be easy.
I'm 6 years outdated in the model aircraft hobby. The technology has advanced in the past 6 years. Model aircraft designs has become advanced, and smaller. Drones, multicopters are practically everywhere now.

But, I guess, the basic principles of model aircrafts hasn't changed.
So, I should be able to catch up again.

Let's start.

Comments

Selecting the Correct Gauge Wires for your RC Models

When we are building RC models (aircrafts, multicopters etc.), something we typically overlook is what type of wires to use to distribute power in them. Usually, we try to reduce the weight of the model, so we tend to go with smaller wires. But, we cant expect to put in small circuit-wires and have them handle the amount of power needed. If you look at the wires that comes in the output leads of a Li-Po, or the wires that comes on a standard XT Jack, you'll notice that they're quite huge. Large gauge wires on a Li-Po and XT connectors These need to be huge to handle the amount of amperage that goes through them. So, we should also consider the amperage, and the length of wire needed when selecting the size (gauge) of the wires.

What do the prop size numbers mean?

Have you been trying to shop for propellers - either online or at a hobby shop - and got confused of the numbering used to denote the size of the propellers? You see things like " 10 x 4.5 CW ", or " 8055 CCW ". What do these numbers mean? A 8 x 4.5 CW and CCW Propeller Set It's actually quite simple once you figure it out. The first number denotes the diameter of the prop (length from tip-to-tip). The second number denotes the pitch of the prop. Here, the pitch is denoted as a length, not a angle. Let's see how that works.

Make Your Own Jupmer Wires for Electronic Breadboard

Note: After starting the 'Tips and Tricks' section I wanted to do my own 'tutorial'. So, here's my first attempt of it. Hope you all find this useful, and sorry about the low quality of the photographs, my camera is just a 2MP. If you, like me, like to experiment with electronics, then you'd probably use an electronic breadboard (also known as protoboard or project-board). These allow you to construct and test circuits without the need to permanently soldering the components. The problem with these is that you have to use wires to connect the components across the bus lines. We normally use single core circuit wires for this purpose, but they tend to bend, break and get stuck in the breadboard when used repeatedly. This may cause short circuiting the bus lines and could be the failure of your circuit. A better option would be to buy a 'Breadboard Jumper Wire' kit, such as this. A Breadboard Jumper Wire Kit These have sets of wire of differ...

Code 42

Search This Blog